How It's Done

The First Thing to Check When the Truck Won't Start in August

It's the battery. It's almost always the battery. Here's the five-minute proof before you call anyone.

This one links to gear. Gear links may be affiliate links (Amazon); if you buy through one we may earn a small commission at no cost to you. We only list what we'd buy again. Details.

Heat kills more batteries than cold does. Cold makes a weak battery obvious; heat is what made it weak. By the end of a Texas August, a three-year-old battery has been cooked from the inside for ninety straight days, and the morning it quits is a Tuesday when you’re already late.

Before you call a tow, buy a starter, or let a shop “run diagnostics” on a problem a ten-dollar meter can find, do this. Five minutes, one tool, no guessing.

1. Listen before you look

Turn the key and pay attention.

  • Rapid clicking: battery. Not enough juice to hold the starter solenoid in. Ninety percent of August no-starts sound like this.
  • One loud click, then nothing: could be battery, could be a starter. Keep going; the meter decides.
  • Cranks slow, like it’s tired: battery, or a bad connection to it.
  • Cranks strong, won’t fire: not the battery. This article isn’t for you today. Sorry.

2. Look at the terminals

Pop the hood. If the terminals have white or blue-green crust on them, you may already have your answer. Corrosion is an insulator. A battery can be fine and still not deliver through a quarter inch of fuzz.

Wire, post and clamp sides

Battery Terminal Brush

Three dollars of wire that fixes half of all "dead" batteries. Keep one in the glovebox.

Pull the negative clamp first, then the positive. Brush both posts and the inside of both clamps until they’re shiny. Put the positive back first, then the negative. Try it. If it starts, it was never the battery. Buy a second brush.

3. Read the voltage, engine off

Auto-ranging, DC volts to 0.01

Digital Multimeter (auto-ranging)

The only diagnostic tool most truck owners ever need. Auto-ranging so you can't set it wrong at 6 a.m.

Meter to DC volts. Red probe on the positive post, black on the negative. Read it.

A battery that reads 12.6 at night and 11.8 the next morning with nothing on is holding a dead cell. Replace it. Don’t argue with it.

4. Read it while cranking

Have someone turn the key while you watch the meter. A healthy battery stays above 9.6 V under load. If it drops to 7 or 8, it’s done, even if it read fine sitting still. This is the test the parts-store “free check” is doing, and you can do it in the driveway.

5. Read it running

If it starts, leave the probes on. You want 13.7 to 14.7 V with the engine running. That’s the alternator charging. Under 13.2 means the alternator isn’t keeping up, and your new battery will be dead in a month if you don’t fix that first.

What to do about it

If the battery’s done, replace it with the highest cold-cranking-amp rating that fits the tray. The cold number doesn’t matter for cold here; it matters because a bigger battery has more plate area and survives heat longer. Check the date sticker on the new one: anything over six months on the shelf, ask for another.

Then keep a jump pack in the truck. Not cables. A pack.

1500 A peak, USB out, built-in light

Lithium Jump Starter (1500A+)

Replaces the stranger with the cables. Charge it twice a year and it'll start a V8 in a Walmart lot at 104 degrees.

It’s the difference between a five-minute delay and a conversation with a stranger about whether red goes on first.

The short version

Click-click-click, clean the terminals, read 12.6 at rest and 9.6 cranking, 14 running. Anything else is a different article. Get back to work.

While you're here